Modular Bathtub Tray/Organizer

prusaprinters

<p>This is a sturdy, easily accessible and infinitely extendable organizer for your bathtub corner with enough room to place all the shampoos, soap, gels and stuff for a whole family within reach where it's needed. It's also very printerfriendly with no overhangs and moderate printing time.</p> <h3><strong>Print Instructions</strong></h3> <ul> <li>Print "Tray.stl" for every lower tray</li> <li>Print as many "Joint.stl" as needed to connect all the trays, one joint for two trays</li> <li>Print "TOP_Tray.stl" for the top tray when using suction cups</li> <li>Print "TOP.stl" for the endcap at the top <em>Important: print the parts oriented as shown in the slic3r screenshots. See "Print Settings" for how to setup your slicer software.</em></li> </ul> <h3><strong>Assembly</strong></h3> <p><em>Note: print with 0.2mm layer height to have the parts fit together just right with only little force needed. Once connected they won't come apart without some extra force applied.</em></p> <ul> <li>Stick one "Joint.stl" into the top of the lowest "Tray.stl"</li> <li>Push the bottom of one "Tray.stl" onto the joint. If it is the topmost tray and you want to use suction cups, use "TOP_Tray.stl"</li> <li>Optional: put some silicon feet on the bottom of the lowest tray to allow water to flow out underneath</li> <li>Optional: slide two suction cups into the slots of the "TOP_tray.stl" as seen in the pictures. The slots are 9mm wide</li> <li>Put the endcap "TOP.stl" into the top tray<h3>Print Settings</h3> </li> </ul> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK2S</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>0.2mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>25% Rectilinear</p></div><br/> <strong>Filament:</strong><br/> FormFutura PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>Disable supports in your slicer software, it might calculate some for the "Joint.stl" which are not needed.</p> Slic3r settings I used:</div></p> <ul> <li>Layer/First Layer Height: 0.2mm</li> <li>Vertical Shells: 3</li> <li>Solid Layers Top/Bottom: 3</li> <li>Seam position: rear</li> <li>All "Quality" settings except "Avoid crossing perimeters"</li> </ul> </p></p></p> Category: Bathroom