Modular Adjustable Door Sweep

thingiverse

This is an adaptable adjustable door sweep crafted to be printed out of a flexible material like Nylon or NinjaFlex. Three slots enable individual sections to be adjusted for height and angle, allowing them to be tailored to glide smoothly over uneven floors. Each section measures 200mm in length, requiring four to fit a standard door. When attaching, gently tighten the center screw until there's just enough friction to keep the sweep parallel to the floor and as low as possible. Then open and close the door once to adjust the sweep to its highest position needed to clear the floor. After that, tighten the center and outer two screws. The sweep should now be as low as possible without catching on the floor. Print Settings Printer: FlashForge Creator Pro Rafts: No Supports: No Resolution: 0.1mm Layers Infill: 100% Triangular Notes: Printed using Taulman Bridge Nylon extruded at 245C, hot glass bed at 55C with a coat of undiluted PVA glue, enclosed chamber at 40C, 50mm priming pillar, nozzle wipe before printing. Total print time per sweep with my settings is 3 hours 15 minutes. How I Designed This Designed in Autodesk Design 123D based on a 2D sketch extrusion with a filleted top edge and a camfered bottom edge. Holes are sized for standard drywall screws.