modular 100w led "sun blaster" casing

thingiverse

This project was inspired by a YouTube video that can be found at https://www.youtube.com/watch?v=c--5c3Egv4E. Most of the electronics and optics-like materials mentioned in the description are easily accessible. The round rocker button used is similar to those found on car 12V toggle switches, which can be purchased online through eBay at https://www.ebay.com/itm/5-X-Car-12V-ON-OFF-Round-Rocker-Boat-Toggle-Switch-Push-Button-Black/372086260952?epid=860674481&hash=item56a211c4d8:g:uqkAAOSw0ThZoNJc. The project was designed using SketchUp software. Here are the parts used: Generic Slice: A base part of the structure. Front Slice: Similar to the generic slice, but also includes screw shafts for led and heat-sink. Handler Pole: A holder for the casing Supporters: A supporter or connector connects two slices (generic/front). 12cm: A supporter with 12cm length (slice to slice, not from the pins). 5cm: With 5cm length. The "w" letter stands for "with," indicating that this supporter includes a support for voltage booster. Assembly: This is a modular design, so you can assemble it as you like. My Assembly: 1. I printed front_slice. 2. I printed generic slices. 3. I printed 12cm supporters (5 of them). 4. I printed 5cm supporters (4 of them). 5. I printed 5cm "w" supporter. 6. I printed handler pole. All parts were printed with a 50% infill. I connected the supporters in a pentagon-like shape, alternating between them (as seen in pictures). The 5cm "w" supporter was attached to the lower-middle-back side for the voltage booster. M6x20mm screws were used to reinforce the entire structure. The holder was secured with four zip-ties (4.8mm width) to two 5cm supporters. You can print, alter, or distribute this design as you see fit. However, you may not sell it or engage in any commercial activity involving it. I assume no responsibility for any issues caused by this design or description. Use at your own risk.