Modix Filament Hook for 2020 Enclosure Extrusion

thingiverse

This is a filament hook, that can hang a 1kg spool up against the walls inside the top of the Big60 v3 enclosure. This turns your printer enclosure into an efficient filament dyer, as it stays about 46°C (116°F) when the bed is set to 90°C and all the doors are closed. For installation, you need one 2020 t-nut with M5 screw hole, and one M5x12mm low-profile socket-head screw (these are used for the enclosure assembly, and you should have extras). You will also need a 3mm ball end hex key. The key WILL reach, but you can only turn it 1/2 a turn at a time, before having to remove and reposition it. (Luckily, it only takes a few full revolutions of the screw to tighten up.) Modix Big60 side is 880mm (~34-5/8") deep, 840mm (~33") between the upright 2020 extrusions. The filament hanger is 50mm (~2") wide. Four filament hangers and spools can be hung on each side. Space the hangers out 160mm (~6-1/4") between them, or 210mm (~8-1/4") center-to-center, and 1/2 that much from the inside face of the vertical 2020 extrusion, which is 130mm (~3-1/8") space or 105mm (~4-1/8") to center of hanger. 1kg spools tend to be about 200mm (~7-7/8") in diamater, so this leaves a nice little gap between hanging spools.