Modified Visor, face mask, shield for smaller printers and comfort

thingiverse

This is a revised design for a face shield that can be printed in smaller printers (150x180mm), featuring a rubber band and forehead support, created by Graziano Bertolino.\r\nOriginal 3Dverkstan visor found here: https://3dverkstan.se/protective-visor/\r\n\r\nA modified 4-hole puncher with a magnetic end stop is used to create two punched holes on an A4 sheet. The end stop is adjusted during the first sheets, as shown in the attached image.\r\n\r\nABS and PETG are preferred materials for handling strong antibacterial fluids.\r\n\r\nA thicker (0.3mm) transparent A4 sheet can be found at https://panduro.com/sv-se/produkter/skapa-dekorera/gjutning/plastformar/kraftig-plastfilm-a4-03mm-5st-672079\r\n\r\nNote: This design with a gap in the top is not fully protective against drops from above. The stretch material is harder to clean than the original version, but it's much more comfortable.\r\n\r\nPrint this design with solid walls as shown (depending on nozzle size) and increased flow and heat for a robust part. The PetG version is very flexible and doesn't break easily.\r\n\r\nStay safe and help each other out!