Modified Prusa Enclosure PSU Holder - Outside Table Leg

thingiverse

Note from 3/2/19: I revisited this project to add photos and remove the "In Progress" label. In doing so, I became confused about which files were new or old, so I removed them all and re-added them. This means that even if the files appear fresh, they are actually the same ones as before. I've added images of the upside-down (USD) version of this PSU holder. Since I have two IKEA LACK enclosures stacked on top of each other, I was able to utilize this configuration. However, I haven't printed the right-side-up (RSU) version yet. ---------------- I'm currently working on adapting an enclosure design found on prusaprinters.org. My twist is that I'll be making the bottom table into an enclosure as well, specifically for a different printer. The stack will sit on a larger, flat desktop. Originally, the PSU holder would have been placed inside my lower enclosure, but I'm relocating it to the outside of the table leg on the lower table. This move positions the PSU even closer to where the wires exit the enclosure. A right-side-up version is also available for those who want to try mounting it to one of the legs on the upper table. In this setup, there's no space to place the PSU until after you've installed the enclosure over your printer. This might be inconvenient if you frequently take the top off and on. For now, I'm not planning to use the right-side-up version, so its effectiveness remains untested unless someone else posts a make. **Files labeled with "RSU" are designed for power supplies oriented like when mounted on the Prusa MK3 frame. Files containing "USD" have the power supply mounted upside-down.**