Modified Nintendo Switch Joy-con grip (remixed)

thingiverse

Credits go out to manabun for the fantastic original design! Check out the original here: https://www.thingiverse.com/thing:2769344 I made some modifications to the design so it prints better without supports. The slot got a tweak to make it easier to fit the joycon in place. The shoulder buttons were also adjusted to provide a snugger fit in the grips and a more comfortable feel for your fingers. The fit on my printer is spot-on, but be aware that results may vary depending on your printer. Many users have mentioned getting 96% success with this design. If you only scale it down in the Z direction, the width should stay the same as the joycon. So, try scaling it up a bit in your slicer if the fit is too loose or vice versa. A helpful tip: Print just the lower sliding part first to check the fit before printing the whole grip!