Modified Link Plate for Triple Noctua Fan

thingiverse

this is a small modification to the original Link Plate. I had the issue that the edges of the side mounts were too thin/brittle and would break at last part of the print. To solve this I modified every fan mount edge of the print to be slightly thicker than originally. While modifying I also found some leftover elements (too small to be printed, but enough to move the design) that would lift the print a few millimetres off the bed, causing it to print supports underneath the front face of the mount. in total this modification has the following: - Slightly thicker edges of each fan mount (by just a few millimetres) - Each flat side is cleaned up to make sure there are No leftover elements that could disrupt the end result. - sharp edges on the inside of the side mounts on the original print are also removed, making it look slightly smoother.