Modified Belt Geometry Motor Mounts for X5SA Pro

thingiverse

I modified the source for the X5S to the alignment plate for the X5Sa pro so that the belt is more or less parallel without an offset. I also reduced the insert width so that it slides more easily into the extrusions. The remainder of the parts cad be obtained from the original part: https://www.thingiverse.com/thing:3584805 Edit: 2-21-2021: I also included my deepened Sled plate that should ensure it the extra potential height doesn't affect the stepper / motor. Be sure to print this it at 80% infill or better. Edit (2-20-2021): I've added a 8mm shifted version. For those who do have it slightly off and want it "perfect" try the 8mm one first, specially if you have one of the newer X5SA Pro models. I was also asked what screws I used, although the original listed it works well, I improvised a bit mine below: 8 x M3 12mm M3 screw 4 x M4 nuts (7mm outer dimension) 2 x M4 x 30mm screw The M4 screw has the first nut tightly screwed on before inserting it to keep it in place and then the other nut on the outside. Edit (2-13-2021): corrected a few typos. :-/ The offset I used is close, I did a few measurements with another forum member and his was off by almost 3mm.. I was off by about 0.5 on mine, it seems to have something to do with the difference in something on the front mount, if thee is demand for it, I'll remix and add a shifted 8mm version from the original which is about the average different between mien and his, but it's fairly minor compared to the original on the X5SA Pro vs X5SA.