Modern Toilet Paper Holder

thingiverse

My wife had grown tired of the low-quality chrome bathroom fixtures that came standard in our home. This toilet paper roll holder is sturdy and easy to print. You'll need a few additional hardware components: 2 - 3/8" bolts 1 - 3/8 steel washer 1 - 3/8 nylock nut 1 - 3/8 neoprene washer 4 - screws and wall anchors of your choice (I used M4 x 20mm bolts and these wall anchors: https://thd.co/35VGoDM). You may also want to have some epoxy on hand. See the assembly instructions below. Assembly: 1. After printing, add a small amount of epoxy into the cavity in the back of the right TP piece, then insert one 3/8 bolt until it's flush. 2. Place the steel washer and other 3/8 bolt through the back of the left TP piece. This should spin freely, so don't use any epoxy here. 3. Place the neoprene washer onto the end of the bolt on the front of the left TP piece. 4. Add a small amount of epoxy to the opening for the nylock nut on the arm TP piece. 5. Screw the arm TP onto the left TP until you get the desired tension. You'll need an open wrench or socket wrench to hold the back of the bolt in place. 6. Finally, mount the pieces on the wall. I recommend mocking up where you want it to go. Once you have this marked, use tape or a pencil to mark where each side will go. It's helpful to have someone hold the pieces while you check for level. Good luck with installation. Take your time and it will look great!