Modern simple hook with invisible mount

prusaprinters

UPDATE 29/02/2024Some people requested bigger chamfer on the mount holes to accommodate bigger screw heads.Original 2mm chamferUpdated 3mm chamferUPDATE 31/01/2024After first feedback it seems that the original tolerance 0,05mm is too tight for some printers. I found this as a sweet spot after several iterations, but I understand other printers might not allow for such tolerance.So I am adding hooks with 0,1mm and 0,15mm tolerance. The mount stays the same.This should be OK for most printers as any bigger tolerance could cause play between mount and hook.____________________________________________________________________________________________________________When renovating our hall, we wanted some very simple, yet modern hooks, with possible no visible mounting points / screws. So I came up with this design.The fit is quite tight, I wanted to have no play, so it might require some dialing.There are small bumps at the end, so the hook clicks nicely in place: Print instructions0,1mm layer heigh - or just as low as possible to allow good insertionPrinted in PLA, but any material should doPrint front side down - mount side up for best printability and front visible finishNo supports needed50% infill4 perimetersAdditional hardware needed2x 4x12 screws (or longer)