Modern Salt Shakers

cults3d

A set of two ergonomic salt shakers, easy to grip and easy to pour. I say salt, because I prefer my pepper ground fresh, so I don't recommend anyone use pre-ground pepper ever! PSA: If you use pre-ground pepper, switch over now! The flavor difference is huge. The holes are 2mm, that should be enough for a good pour, although you may need to use a poker needle to clear the holes fully after the print. The caps are sized to fit well, but if they're too tight, just twist them back and forth a few dozen times until they wear in. The larger shaker allows a great deal of control over the amount of salting depending on its orientation, so whether you need to salt just a little or salt a whole table of barbecue quickly, it'll do the job! The smaller shaker has a good pour, not as much control though, but a small foot print. Recommended print settings: 2.8mm walls for durability and looks (this will make it solid, but still allow for infill in places like the cap body) Warning: Print in a food safe material.