Modeller Vice

prusaprinters

<p>To print:</p><ul><li>2x čelist (100% infill)</li><li>1x podstava (20% infill)</li><li>1x pojezd (20% infill)</li><li>1x hřídel_1 or hřídel_2 (100% infill)</li><li>1x ségrovka (100% infill)</li><li>Optional: 1x úchyt_1 and 1x úchyt_2 (20% infill)</li></ul><p>&nbsp;</p><p>Assembly:</p><p>Print all parts and regarding used material (recommended ABS) you may need to clean the thread on <strong>hřídel&nbsp;</strong>with file. After filing try to cut it slowly through thread in <strong>pojezd</strong>. After this attach <strong>čelist</strong> to both <strong>podstava&nbsp;</strong>and <strong>pojezd</strong>. Attach <strong>pojezd </strong>to <strong>podstava</strong>, push <strong>hřídel&nbsp;</strong>through hole in <strong>podstava</strong> and tight it up with <strong>ségrovka</strong> (stick it in the ridge on <strong>hřidel</strong>). If you printed <strong>hřídel_1</strong>, take a nail and push it through hole in it. Take some screws and attach vice to wooden desk. Optionally print two additional parts. You will also need a metal stick with 5mm diameter or long M5 screw and M5 nut. There is a small hole on <strong>podstava&nbsp;</strong>under the big hole. Bend the stick to “L” shape and put it in that hole and cut the M5 thread on the other side (if you are using M5 long screw, bend it as well and cut off the top part for wrench). Then slide it through <strong>úchyt_1</strong>, put M5 nut to <strong>úchyt_2</strong> and screw it in. Now you can attach this vice to any table according the length you have left on stick or screw.&nbsp;</p>