Model A flag Holder

thingiverse

This is designed for a 1931 Model A car, specifically for holding a flag around a 2.5 inch radiator neck. The holder can accommodate four stick flags measuring 4 3/16 inches in diameter. It features 5/16-24 threaded rods. Print Settings: Printer: Qidi Tech 1 Resolution: 0.1 Infill: Approximately 50% Notes: This model has not been printed or tested yet, but it's recommended to use high-resolution settings as it may be exposed to windy conditions during parades. The infill percentage should also be increased for better wind resistance; 50% was a tentative guess. Post-Printing Breakdown: 1st Part: The main component features a threaded rod and a hole to accommodate the radiator neck. 2nd Part: A plate with grooves is designed to hold the flags in place over the threaded rod. 3rd Part: A wing nut with matching threads secures the assembly together.