MOD-t Cooling Duct

thingiverse

This 3-part duct for your New Matter MOD-T printer channels the airflow from the bottom vent towards the nozzle to enhance the printing of overhangs - compare the bunny ears with and without the duct. Print Settings Printer: New Matter MOD-t Rafts: No Supports: No Resolution: 0.2mm Infill: 20% Notes: UPDATE: Initially printed this on another printer, but I re-printed this on my MOD-T and it works perfectly fine! Post-Printing To secure the housing in place, unplug the hot-end and slide the housing into position from the back. A large rubber band will suffice to hold the housing firmly in place, or you could use tape. Alternatively, you can opt for a more permanent solution by gluing it if you're confident enough. If you prefer less airflow over the nozzle, simply remove the vent part and the air will exit through the front instead.