Moblite 6 Race Canopy

thingiverse

I designed this for the moblite 6 with the help of RCgroups support. The weight ranges from 0.5g to 1.2g For a lighter print, print a 0.2mm layer height on a 0.4mm nozzle. The infill on the first 0.8mm determine the weight. For example: if the first 0.8mm you use 15% infill with no top layer nor bottom layer. then you will end up with 0.5g. Trade off between infill, strength, and protection. The main settings to play with are perimter/shell and infill with no top or solid layer for the first 0.8mm as thats the height of the cover. There is a support that goes on the bottom side and screws in from the side. This support holds the camera down against the moblite frame. The original front screw hole can be used to adjust the camera angle. If you leave it out, then its around 10 degrees. From there, adding it and cranking down makes the camera angle go up. Use a custom placed support under the camera lens shroud. There's a big set of screws on amazon for $7 that has the screws that fit the moblite. It comes with 1.2mm screws. I like the 1mm screws. You will need 1.2mm x 4mm, 5mm or 6mm will work also As always with these smaller prints, print 2 at a time to reduce heat soaking and warping from the nozzle staying over the print. I also always use fans to lock in the plastic from layer 2 and up on abs and nylonx. *********moblite race canopy v2" has the hole for the the spi receiver antenna. Wrap the antenna around the bottom of the flight controller and then into the bottom of the canopy antenna hole. Before you push it through the hole, put it inside a 60mm peice of heat shrink and shrink it down until the last 10mm. That last 10mm will sit snug inside the canopy hole. The antenna will now stay straight while flying, and even in a crash, it just pops back into place, or can be easily bent back into place over and over Rhcp upgrade: https://youtu.be/rRi4nAujLpo