Mobius 3 Mount to Stepper Motor Dampener

thingiverse

I designed this for use with the CR-10, specifically paired with the Voron Designs Mobius 3 Extruder. The design is intended to work seamlessly with a stepper motor damper on the CR-10, though it can be adapted for other printers as well. To secure the extruder in place, I employed M3 Nuts (x2) at the bottom of the print, each one situated on either side for easy access. To assemble this design, start by attaching the stepper motor dampener to the printed mount with two M3X5 screws and M3 Nuts (x2). Next, position the Mobius 3 Extruder so that the Nema17 faces away from the mount. Insert a M3x8 bolt through one of the holes on top of the part, which is counter-bored for smooth operation. Fasten this bolt with a M3 Nut on the Stepper Motor Dampener. Then, push another M3x8 bolt with a M3 then M5 washer into the hole and through the mount until it reaches the captured nut on the opposing side. This should complete the assembly process, though you can adjust the position of the extruder by sliding it backwards or forwards using the captured nut slots. Here's what you'll need: * 2 M3 Washers * 2 M5 Washers * 2 M3x8 bolts * 2 M3X5 screws * 2 M3 Nuts