Mobility Scooter Charger Holder - Solax Genie plus

thingiverse

I designed this to hold the charging cable for my Mother-In-Law's folding mobility scooter, a Solax Genie plus, as she was struggling with bending down to plug the charger into the port. This is my first project print that I've created from scratch. I printed this on my Wanhao Duplicator i3 plus (actually my Balco printer, which is just an i3 plus without the USB port). I printed it in PLA with 0.3mm layer height and infill set to 100% (since the user is elderly, clumsy, a bit heavy-handed, and I know she'll be kicking it as she can't push it in hard enough). It took around 125m of 1.75mm PLA. You can print it with smaller layers, but I wasn't too fussed about its look. The holes are designed for M6 carriage bolts. They're tight on the bottom/larger half, but larger on the other so that you need to thread them in the bottom half while they'll just slide straight through the top. The bottom also has a 6.2mm square hole where you can hold the carriage bolts in place while tightening the nuts. This was made for the charging cable of a Solax Genie plus charger, but it should fit other chargers as well since it also fits the charger for the Shoprider Cadiz.