Mobile Phone Stand

thingiverse

This is a basic mobile phone stand with a hole for connectors at the base. It will fit phones like Honor 9 and 10, as well as similar models, even the Sony Xperia XA1 Ultra. Printed without any support material, just a brim was used. The settings were: layer thickness of 0.2mm, an infill density of 10%, and PLA plastic was used. You can add supports if you want or print it from the bottom up by tilting it. You could also personalize it with your name and put cork or rubber pads inside the holder - the choice is yours. The Fusion360 file is included.