Moai Piggy Bank - Remix

prusaprinters

<p>First of all: all the credits for this beautiful model goes to ET-Huang (<a href="https://www.thingiverse.com/thing:144668">https://www.thingiverse.com/thing:144668</a>) and Julien_DaCosta (<a href="https://www.thingiverse.com/thing:2493386">https://www.thingiverse.com/thing:2493386</a>, who remixed it for no overhang).</p> <p>In a attempt to increase my skills in Meshmixer and 3d-Builder* I remixed the statue of ET-Huang / Julian DaCosta to a piggy bank. I created the used fill-opening with screw-cap some time ago .(<a href="https://www.thingiverse.com/thing:3383689">https://www.thingiverse.com/thing:3383689</a>).</p> <p>The model is 200 mm high. The wall thickness is 3 mm, except for the bottom where it is 18 mm to make it flat with the fill opening. The vertical opening at the top is 35x3.5 mm.</p> <p>You have to see the make of CiscoKEB, who printed a beautiful one in white Marble filament.</p> <p>Happy saving :)</p> <p>The Spongebob version (Squidwards house) can be found here: <a href="https://www.thingiverse.com/thing:5104074">https://www.thingiverse.com/thing:5104074</a></p> <p>*Although I was able to create this thing in both programs, the result of the Hollow-function in Meshmixer was a lot better (see picture). On the other hand i had to repair that stl in 3d-builder before it successfully sliced (slic3r). 3d Builder turns out to be a very good STL-repair-tool.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Anycubic</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Kossel</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15% but 10% is Ok</p></div> <p><strong>Filament:</strong> Owl PLA Orange</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>The print tooks about 15 hour. 235 grams of filament used with 15% infill and 3 walls/perimeters of 0.4 mm</p></div> </p></p></p> Category: Sculptures