Moai Lava Magma Lamp

thingiverse

This is a Moai Lava Lamp. You can print it without supports. First, put some tape on the lines and then paint it all over. Remove the tape and insert some RGB light inside. It will blow your mind! Print parameters: 0.2 to 0.24 layer thickness works fine for a 0.4mm nozzle. I recommend using a 0.6/0.8/1mm nozzle to speed up the process. I used a 1mm nozzle on an Anet E12, which is 35cm tall. You can use some rafts, just in case. I also use the Cura option "diffused skirt" to give the surface a real stone look! There are two files: solid and hollow with a 2mm wall thickness. I'm using the Cura option "diffused skirt" to give the surface a stone imitation. The figure has a 2mm wall thickness, and the other one is solid. I'm currently printing with a 1mm nozzle - it will take about 11 hours. Then I'll paint it with rustoleum similar to stone. No other post-printing is needed. Don't print in ABS; I've had bad experiences with it! It's winter here, and I'm not looking forward to that. If you liked this model, please let me know! And if you can buy me a coffee, I'll be very thankful. Happy printing!