MN90 - D90 Rear Roll Bar with Tire Carrier

prusaprinters

<p>MN90/99 D90 Rear Roll Bar with and without tire carrier. You'll need to get quite a bit of support for this to all work; but it turned out really well. Both options are included in the file.</p> <p>You'll need 2 x M2 15mm or better to hold the roll bar onto your truck and one M2 (10mm or better) if you want to hold the tire on as well.</p> <p>Update: 7/19 - Add a middle support for the top bar and better supports for the tire carrier into the bar that supports it. Also added fillets to makes the pieces look welded.</p> <h3>Print instructions</h3><p>Supports are required; though I did get away without them for the top most bar. 0.2 or 0.35 work well depending on the detail/smoothness you're looking for.</p>