MN78 1/12 scale rear bumper with tire carrier

thingiverse

This is my second, and last rear bumper for the MN78 model. I plan on updating this model as needed so suggestions and feedback are welcomed. The bumper features a swing-open tire carrier, two shackles/mounts and a hitch receiver. In the pictures above, the [jerry can](https://www.thingiverse.com/thing:2571463/files) is printed at 50% of it's original size, and the [high lift jack](https://www.thingiverse.com/thing:3513415) is printed at 60% of it's original size. I haven't tested the hitch with anything yet, so I'm not quite sure of the fitment. I made it the exact same size as some WPL model I could find though. I do plan on releasing a much sturdier hitch once I have a trailer Required Hardware: - Tire Carrier wheel mount: use original tire screw or any 1x M2.5x10mm or longer - Tire Carrier to bumper mechanism: 1x M2x10mm - Shackle and Hitch receiver: 3x M2.5x8mm Printing Notes: - Everything pictured was printed at 0.2mm on a 0.4mm nozzle - I've oriented the parts in the direction which I found the easiest to print from. - The bumper will need supports - Use supports lightly on the tire carrier part, the mesh is thin and easily broken when removing support. This part is hands down the hardest to clean - Hitch and Hitch stub can be printed without support - Shackles is best printed with "support on build plate only" - I've printed mine out of PETG, but would recommend PLA as well.