MN D90 Body on WPL RC Chassis Conversion Kit

thingiverse

So you just got the beautiful MN D90 body, but you're too lazy to build a chassis or spend money on another one. Why not mount the body on your existing modded WPL C Series chassis instead? You can print the rear mount at 25% infill, but make sure to print the axle truss at least 50%. Also, trim the surface where the link rod mount is so it can rotate smoothly, or you'll risk breaking the axle truss. *Make sure you have good bed adhesion while printing the rear mount* *First layer at least 50% speed or lower* *Axle truss orientation: follow as shown in the attached picture* You'll need two 10mm M3 screws and two M3 lock nuts to complete this project.