MMDVM Duplex Hotspot Case

thingiverse

This is a remix of https://www.thingiverse.com/thing:4981057 and https://www.thingiverse.com/thing:2096226. I recently purchased an MMDVM HS Dual Hat Duplex Revision 1.3 Hotspot Board with OLED. I couldn't find a case that had the cutout for the display and LEDs so I did a remix of the lid mikeymakesit made for the case by frankwatervoort. I added the cutout for the display and the LEDs, enlarged the antenna holes, and reduced the thickness of the lid. I felt like the lid was a bit too thick. The only thing I did to the case was remove 3mm from the top. I did this to make the display a bit closer to the window. I used some 4-40 x 1/2" threaded nylon standoffs to attach the boards inside the case. The lid is held on by #6 sheet metal screws.