MM711 Parts

thingiverse

These are the parts for the MM711 mouse, not the entire mouse but outside parts. Mouse buttons, side buttons, and base. Mouse buttons are trimmed on the bottom as the original had a ridge that would travel into the shell. Side buttons are longer and further out than the original MM710/MM711 buttons. Base has been revised for full print if you don't care much for weight. I would upload the inner shell part of the mouse but it requires so many overhangs and supports would make it hard to take apart and clean up. For the mouse buttons, print with orientation on side that is most flat. Mirror to print left button as well. For the side buttons, print orientation flat on the side so the buttons stick up.