MM2 Dremel 225 Flex Shaft Mount

thingiverse

To integrate a Dremel 225-01 Flex Shaft onto a MendelMax 2, follow these steps: first, unmount your hot end/extruder/fan. Next, install the mount on the underside of the X-Carriage's hole, where the hot end was previously positioned. Proceed by removing the knurled plastic nut from the Dremel 225 tool end. Then, insert the Dremel 225 into the mount and secure it with the removed knurled plastic nut. The Dremel 225 will hold very securely in place due to the tightening action! This sturdy setup is perfect for milling circuit boards and experimentation. It's a simple yet effective addition to your MendelMax 2.