MKS TFT28 LCD Case and tilting bracket

thingiverse

Case with tilting bracket for my MKS TFT28 LCD display. I needed a good case for my MKS TFT28 LCD display after creating a case for my MKS TFT32 LCD display. I thought MKS28 and MKS32 were the same, but they are not at all. The MKS TFT28 has much larger print/PCB, so I had to make the model larger. No screen retention is available, so I built in retention in the lid. More components are closer to the edges, so I pushed out the sides. Mounting holes are very close to the edges, so I pushed out the sides to make the piece strong enough and to make room for a M3 nut cutout. Autodesk 3D view: http://a360.co/1PxCmrw BOM: 4x 35mm m3 screws to assemble case, lcd and lid and 4x M3 nuts 4x M3 screws to attach the CaseBrackets Left and Right to the TFT28 Case and 4x M3 nuts to attach CaseBracket to the TFT28 case 2x 20mm M3 screws to attach MountingBracket to the CaseBrackets 2x M3 nuts to attach the MountingBracket to the CaseBrackets. Some M3 screws are also needed to fix it to your printer. Print Settings Printer: JennyPrinter Rafts: No Supports: No Resolution: 0.2 Infill: 20% Notes: I've printed using a 0.4mm nozzle. I have also printed with 0.25mm layers with fine results. 2-3 Perimeters The CaseBrackets and MountingBracket should be printed with 3 perimeters and 70% infill. Do not reorient it, as it gains maximum strength by the current orientation. Post-Printing Insert m3 nuts into cut-outs - Add glue if they are loose. Use heat if you can't get them in there. Attach CaseBrackes using 4x M3 8-10mm screws. And insert 2x M3 nuts. Insert the MountingBracket in case you need to screw in the M3 nuts into the CaseBrackets. MountingBracket mounting holes are placed 35mm apart, center to center. Custom Section Future firmware updates Listing it here, as it can be a bit hard to find otherwise. Direct Github link to Makerbase-MKS TFT28 files.