MKS + Mosfet Case

thingiverse

I wanted to manage my cables a little better, so I crammed everything up in this smiling box. It might be a little tight installing all the cables, but once done, it's much nicer to look at. I had to run some cables under the boards, they are elevated off the base quite a bit, so it should be okay. It helps to zip-tie the cables right inside the box and right outside the box, which keeps the cables in place without exerting force on connections inside the box. Two 40mm fans are optional; I didn't really need active cooling since I installed the MOSFET for the hotbed, but I kept it there just for peace of mind. Use M3 bolts to fix the boards to the case and then the lid to the case - you're good to go! Please note that this case is designed specifically for the MKS board Gen L and MOSFET model; the screw holes may not fit other types of MOSFETs or control boards.