MKS / Makerbase 1.3" OLED case

thingiverse

This is a custom case designed for the MKS OLED screen that can be found in places such as eBay, AliExpress, and Taobao etc. Edit: This design was created at a time when only 1.3" screens were available. Nowadays, 0.96" screens seem to be more common! Information can be accessed at http://reprap.org/wiki/MKS_12864OLED Creators who want to patch the firmware should visit https://github.com/makerbase-mks/MKS-12864OLED I've made a few adjustments so that this case can be printed with connectors sticking out from the back or fully inside. Some specific supports are included for my printer setup, which is a Tinyboy/Mini Fabrikator on 6mm tall feet (http://www.thingiverse.com/thing:981018). The case consists of two halves. There might be some lock tabs that break off because they're quite thin but aren't necessary since the two halves friction-fit together through the four square pillars in the back side corners, also serving as PCB supports so it doesn't move when buttons are pressed. Edit: I'm posting this link here since it may prove to be extremely useful for someone who wants to get OLED support working on the latest Marlin firmware (v1.1.0 at the time of writing). The branch with necessary changes is provided, using an MKS Base 1.1+ mainboard: https://github.com/X3Cutor/Marlin/tree/mks_spi_sh1106_oled Print Settings: Rafts: Don't worry about them Supports: No Resolution: 0.1 Notes: Tolerances are tight, so try not to attempt this as your first print and do it on a well-calibrated printer. Issues with warping have occurred when using PLA, use any tricks you know to prevent that. The back can be printed with built-in supports but printing the back and supports separately will probably result in straighter outcomes, then attaching the supports with CA or hot glue as necessary for your plastic type.