MKS gen v1.1 Case

thingiverse

Case for the MKS Gen 1.1 Board, Compatible with Sunhokey i3 Old Version. I'm planning to put it through rigorous testing soon and will share detailed photos of the results by next week at the latest. The design accommodates three 40mm fans and measurements are provided in centimeters. While every measurement is meticulously calculated, I do acknowledge a small margin for error, as the initial dimensions were based solely on outer card measurements. If you're among the first to print this case, please don't hesitate to share any discrepancies you may find during production. Notably, due to incorrect placement of mounting holes, users should expect minor flexing of their card. This enclosure consists of a two-part design. Simply print and assemble it, then secure it within your Sunhokey i3 setup. A separate component forms the upper part where you'll fasten your board using standard bolts, readily available at any hardware store. Essential Fittings Needed: - 40mm fans. - Optional but recommended: M4 and M3 threaded taps for PLA-based prints, to ensure sturdy mounting of the case's interior components.