MKS Gen 1.1 Box for Sunhokey Prusa i3

thingiverse

I printed a case for my Sunhokey Printer's MKS Gen 1.1 controller board in FreeCAD. The project requires the following materials: You'll need some M3 screws and nuts, so get those ready. To build this case, you'll need to print two parts: the base and the lid. You'll also need four M3 5mm screws with nuts. I printed my case without any support material. To secure the nuts, I used hot glue. Unfortunately, I misplaced one of the lid connectors slightly, so I had to use a rasp to remove some material from the MKS Gen 1.1 controller board casing to allow it to slide in smoothly (as shown in the last picture). Here are the print settings I used: Printer: Sunhokey Prusa i3 Rafts: No Supports: No