MK8 Extruder Wire Loom Cable Clip For Ender-3

thingiverse

I use this clip with the Bullseye duct horizontal wire management style, which involves the cable management channel on the Bullseye and Petsfang pulling the loom in a horizontal direction. The built-in Ender 3 extruder clip fails to hold the wire tight enough and lacks sufficient horizontal stability. This alternative clip features a small horizontal platform and holes for cable ties that securely hold the cable horizontally. I employed an M3 x 12 screw, but the original factory screw is just long enough to use. The hole might be slightly tight, so it's best to run the screw through it first to make installation easier. Print with 'support to bed only.' I used 100% infill due to the small size, but you could likely reduce this to a lower percentage. The sample shown was printed in the orientation displayed in the preview.