MK4 Raspberry Pi case

prusaprinters

This is a Raspberry Pi 4 case, created for my MK4 to run Octoprint. Its mechanism is heavily inspired by the original Raspberry Pi 4 case that I had.To open/close the top slightly press on the sides of the top where the triangles are to unlock the hooks.There is an additional connector to mount it to the MK4. (just note that it is tricky to install, you will have to remove the cover of the electronics box.) I mounted it next to the electronics box of the MK4 so that I could easily route the camera cable to my camera arm mounted on the left side of the X-axis.The case is designed to match the aesthetic of the MK4, just like the camera arm I designed.The long protrusion on the top is there to block the Pi's LEDs from shining out the top so that they are only visible from the hole on the side (or top if you mount it to the MK4).Supports are only required in some small areas, see .gcode file for more information.