MK3S Prusa Super Cover Remix - Centered and Tweaked

thingiverse

UPDATE 07/18/19: STEP files added for v7 model. UPDATE 06/12/19: Design updated to v7. v7 has a 10 degree up-tilt compared to v6, reflecting the angle from original designs remixed. Updated in response to feedback that v6 cover does not leave enough clearance for USB power to Pi for some users. ------------------------------------------------ I love Super Cover design by yetisnack (https://www.thingiverse.com/thing:2918314) and it was one of my printer's first additions. I chose the remix by initialchicken (https://www.thingiverse.com/thing:3610440) because I like mounts for mk3s. After living with it for a month, I decided to make some changes to fit mk3s and adafruit 3.5" better. I also ended up tweaking a few things: - Fixed offset issue, now perfectly centered to print bed - Fixed issue with too much pressure on 3.5" piTFT, now easier to put in and remove (original pressure cracked screen while installing) - Tweaked 3.5" mounting holes for better alignment - Tweaked space for 3.5" screen to center the screen - Tweaked space for stock Prusa screen to remove excess border and now shows only screen - Added two more mounting points for stock Prusa PCB to allow more secure mounting (use shorted screws so they don't poke through front of case) - Centered dial hole in cover to stock Prusa dial. Mine was offset by almost 2mm. To print, no supports necessary but you do have to rotate cover in your slicer about 45 degrees otherwise you will get a build volume error. Design incorporates adafruit 3.5" piTFT (https://www.amazon.com/PiTFT-Plus-480x320-Touchscreen-Raspberry/dp/B017PDWNKE/ref=sr_1_2?keywords=adafruit+3.5&qid=1560085908&s=gateway&sr=8-2). Screen displays/controls Octoprint through TouchUI. I also attached Pi through a ribbon cable so didn't need end cap access from original design. There are two versions available for download, one has an open end cap to use 3.5" screen as a Pi hat and the other has a closed end for people with a setup like mine and want a cleaner look. Let me know what you think!