MK3s+ Bearing Holder

prusaprinters

<p>Needed a bearing holder that would properly hold the bearings on the Y carriage but also fit within the confines of the odd frame geometry of the MK3s frame. This design uses an M3 16mm screw from the top of the carriage into the holder to keep it snugly in place. DO NOT OVERTIGHTEN. Get it snug and you're good to go.</p> <h3>Print instructions</h3><p>I recommend at least 3 walls and 20% infill. Plenty of flex even with CF filaments to get the bearing in.</p>