Mk23 Carbine Body Split With no Rail

thingiverse

My take on PH4SIK's Mk23 carbine body design has been revised to accommodate smaller printers like my own (200x200). The design has been split into two sections, making it easier to print without any issues. The rail was removed from the original design to allow for a flat printing surface. I struggled with upright prints in the past, and this change made all the difference. My printer isn't top-notch, so I had to think outside the box to get this design right. PH4SIK's emblem has been intentionally left out of my version, as it's not my original work. Please don't assume this is my own creation. Two simple adhesion points have been added to strengthen bonding after printing. These small changes make a big difference in the overall quality of the print. To get the best results, please use PH4SIK's recommended print settings – except for printing on its end, of course! Supports are necessary everywhere to ensure a smooth print job. One last note: while it's ideal to print this design in one piece, smaller printers can still benefit from this revised version. Just remember to be patient and enjoy the process!