MK1 focus Shifter bushing

grabcad

This is to replace the worn out part of the shifter that helps side selections (1/2 or 5/R gears) use a lighter for the inside of 3d print for a few seconds to soften the plastic. once shifter piece is cleaned off of old "plastic" slide this (seconds after heating) onto the shaft. you may increase size by a max of 3%, but not recomended. (piece will need to slide slightly up and down inside of the hole). Just used this to fix my focus, Shift seletion is 100% better compaired to previous. This is a basic hollow tube design, take less time to print then it takes to pull out your shifter. (tested this aswell.) Works for 1998-2004 Ford Focus with the MTX-5speed transmission. (Zetec engines, SPI, SOHC and DOHC)ONLY DO THIS IF YOU HAVE VERY SLOPPY SIDE TO SIDE MOVEMENT WHILE IN GEAR.