Mk.82

cults3d

Here's my Mk.82 model with standard or braked (snake eye) tail. The snake eye tail version is fully functional - just blow on the brakes from flight direction to test it out. It's specifically designed for an RC plane scaled at 1:8. This model comes equipped with a screw fuse and hook pins, and here are the recommended print settings: pins should be printed at 0.1mm high or less, using a nozzle of 0.3mm in size, and the infill should be set to 100%. Don't forget to turn off support material during printing. The brake segment requires a single perimeter with a 0.4mm nozzle. For assembly, you'll need some basic tools like a 2mm round profile, pliers, tweezers, a 2mm drill bit, glue for securing the cut pins, a file, scalpel, sandpaper, and a scale. You'll also need to measure out the correct pin length for securing moving parts - this will vary depending on your specific model, but in my case it was 8.5mm for the top assembly parts and 7.5mm for the bottom moving ring part. The tail section is secured by four screws, which should be M2 x 5MM flat head screws along with M2 x 3mm Brass Cylinder Knurled Threaded rods that can be pressed into place using a soldering iron in the designed holes - check out the picture for reference.