MJX X400-Soporte Camara -180º

thingiverse

Simple two-piece support to rotate the FPV camera of the drone by 180 degrees. The standard support of this small drone does not allow precise control (within its limitations :) ) in FPV mode since the standard camera is focused on aerial shots, with this support we invert its position to have a frontal view of the advance, with an approximate angle of 3°. I used the replacement screws from the propellers and the grooves of the original support to secure the components once glued. It leaves enough space for cables and battery compartment opening. Print Settings Printer: Legio 3D Rafts: No Supports: No Resolution: 0.2 Infill: 100% Notes: -I used a 100% infill since it's relatively small pieces. -Part B includes the supports Post-Printing Assembly: 1-Eliminate the supports from part B carefully. 2-Glue both parts aligning the front piece. 3-Secure the support to the drone with camera screws. 4-Connect the camera and secure it with screws.