Mix and Match Coaster Set

prusaprinters

Since doing some redecoration to my living room, decided to make a unique collection of filament paintings (hueforge), base and holder to create your own unique coaster set. My choice was one of each but you can mix and match to create your own favourite set.The holder can hold up to 6 coasters. For each coaster you will need to print one base and glue them together with a super-glue.Coaster Base / Coaster HolderPrint these with 0.20 layer height and about 10-15% infill. You will need to print one Coaster Base for Each Coaster and one Coaster Holder Filament PaintingsAll Hueforge/Filament Paintings, you can print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm and use a tight brim to keep them on printer table and avoid wrapping.MicroworldFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #5 (0.48mm) swap to GrayAt layer #10 (0.88mm) swap to Light GrayAt layer #16 (1.36mm) swap to White for the rest.  SpiderWebFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #4 (0.4mm) swap to GrayAt layer #10 (0.88mm) swap to GrayAt layer #17 (1.44mm) swap to White for the rest.  FacesFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #5 (0.48mm) swap to GrayAt layer #10 (0.88mm) swap to Light GrayAt layer #18 (1.36mm) swap to White for the rest.  Robot FaceFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #5 (0.48mm) swap to GrayAt layer #9 (0.88mm) swap to Light GrayAt layer #16 (1.36mm) swap to White for the rest.   SmileFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #6 (0.48mm) swap to GrayAt layer #10 (0.88mm) swap to Light GrayAt layer #17 (1.36mm) swap to White for the rest.   Mouth KissFilaments Used:PLA Overture BlackPLA+ Sunlu GrayPLA Overture Light Gray PLA Overture WhiteSwap Instructions:Start with BlackAt layer #6 (0.48mm) swap to GrayAt layer #10 (0.88mm) swap to Light GrayAt layer #15 (1.36mm) swap to White for the rest.   Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.