Mix And Match Booster Pack

thingiverse

- Compatible with: https://www.thingiverse.com/thing:4949839 - Common Shaft Diameter: 40mm (1.57") _________________________________ - Buck Major Diameter: 46 mm (1.81") - Buck Usable Length: 179 mm (7.04") - Buck Area: 260 ml (8.79 oz) _________________________________ - K9 Knot Width: 65 mm (2.56") - K9 Usable Length: 163 mm (6.41") - K9 Area: 320 ml (10.82 oz) _________________________________ - Lightened Ball Diameter: 50 mm (1.96") - Lightened Usable length: 163 mm (6.14") - Lightened: 225 ml (7.60 oz) _________________________________ - Steam Major Diameter: 46 mm (1.81") - Steam Usable Diameter: 150 mm (5.9") - Steam Area: 250 ml (8.45 oz) _________________________________ - all molds and "parts" use the same starting and ending diameter so they are all interchangeable - 9.7mm dowels used for each half assembly - all cubes are 101.6 mm (4") or less to be printed on the smaller printers - all base options have suction cups - I would personally glue the individual sections together to form the two mold halfs - Use Platinum Cure Silicone, Shore Hardness 10 = firm, 5 = Medium (ish), 3 = soft. - Smooth-On is a good source: "Dragon Skin 10" for firm, "Ecoflex-00-50" for medium and "Ecoflex 00-30" for soft _____________________________________________________________ - for a quick and dirty toy (will have flashing that needs to be cleaned up) you can use the 3d printed molds - You could also sand and clear coat the mold halves, wrapping the entire mold in electrical tape to seal it - Print with thick walls ex: 4 layers or more with 8% infill _____________________________________________________________ - you can also just print the dick it self, sand it smooth, seal and make a mold the old fashion way, use this way for the best results. _____________________________________________________________ - I recommend printing vertical if possible to get the resolution. - pour the silicone to just bellow the surface then right at the end of the pot life smush the top on using pins (ex skewers) in the alignment hole and a weight to keep it from moving - a good resource for silicone toy making: https://vimeo.com/candiru - Have Fun!