mITX SFF Chassis - Skyscraper Case

thingiverse

**Update 4:** I redesigned the motherboard plate to have press-tabs that allow you to quickly remove it without taking apart the entire case. This gives easy access to the back of your motherboard. I also added round feet because my roommate hated the square ziggurat feet. ----- **Update 3:** I created an alternate version of the PSU Holder, allowing for a full 300mm graphics card by turning the PSU 90 degrees on its side. Keep in mind that this version precludes the ability to have a 140mm fan in the top plate. I also updated the regular PSU Holder with additional support and lifted it up 10mm, allowing for a 220mm graphics card. ----- **Update 2:** I added an alternate version of the Right Riser Card Support, which allows for a 300mm graphics card instead of only 220mm by moving the bottom PCIe plate to the front of the case. This precludes the ability to use a 240mm radiator in the front of the case but opens up space for a pretty beefy CPU air-cooler. The front-panel section should also be swapped to the left, as you probably won't have enough space for cabling if it was on the right. ----- **Update 1:** I added an alternate version of the Right Riser Card Support, which allows for a 300mm graphics card instead of only 220mm by moving the bottom PCIe plate to the front of the case. This precludes the ability to use a 240mm radiator in the front of the case but opens up space for a pretty beefy CPU air-cooler. The front-panel section should also be swapped to the left, as you probably won't have enough space for cabling if it was on the right. ----- I was looking for a no-compromise small form factor PC case that fits all my needs. Unfortunately, nothing like this actually exists. Every SFF case has some sort of compromise; whether it be lack of cooling options, lack of IO or even a lack of portability. So my aim was to create a case that fits all these needs. Features: * 15.5L: 220mm x 220mm x 320mm * Fits a mITX motherboard * Fits a SFX power supply * Fits a 3-slot graphics card up to 220mm * Fits a 3-slot graphics card up to 300mm (alternates) * 2x 120mm fan on front (or radiator) * 1x 140mm fan on top * 2x 92mm fan on the right * Optional carry handle Since all the pieces to this case are modular, you can buy only what you need and adjust it according to your requirements. Materials: * M3 screws: * 14x Makerbeam M3 Square Bolts for cross-beams * 8x 8mm length M3 screws for bottom feet * 2x 32mm length M3 screws for front panel audio * 2x 8mm length M3 screws for front panel USB * 6x Heat Set Inserts for the riser card and handle Unless you want your front I/O to look exactly like mine, you'll need to design your front panels according to your requirements.