MiSTer Sidecar USB case add-on v1.1 for MiSTer - Case Universal

thingiverse

**MiSTer Sidecar USB case add-on** usable with MiSTer USB Hub v1.1 daughter board Sidecar will work seamlessly with MiSTer - Case Universal v5.2, as well as MiSTer - Case Universal v1.2. Four 2.5-3 mm screws are required to securely attach the front and rear panel, serving as brackets that firmly hold onto the MiSTer Case. If you prefer no additional holes, print the no_holes version of the shell. For successful assembly, ensure both panels are slid fully into place only after they have been attached to the MiSTer case. Alternatively, try sliding one panel in completely and then attempt to attach the case while sliding in the remaining panel at an angle. Be patient and avoid forcing it. Panels: Ensure the panels are oriented flat on your print bed and use supports for these panels! The recommended print height is between 0.18 to 0.2mm. Shell: The shell can be printed without supports, with a recommended print height of 0.18 to 0.2mm. For more information: https://github.com/MiSTer-devel/Main_MiSTer/wiki http://www.atari-forum.com/viewtopic.php?f=117&t=34098 -- Also available on shapeways: https://www.shapeways.com/shops/negsol-design