Mister case for A-JAZZ AK33

thingiverse

I've released an updated version of this design, check it out at https://www.thingiverse.com/thing:4721208. This design is based on an original concept by Lee 'Legion' Smith, who granted me permission to publish this thing. I designed this during the Covid Lockdown using materials I had at home. Feel free to modify and adapt it to your needs. This is a custom case made specifically for the MiSTer FPGA computer and A-JAZZ AK33 keyboard. To assemble this case, you'll need some M3, M5 nuts and bolts, as well as some M3 spacers. I've used kits from Amazon that I purchased in 2019. You'll also need USB to PANEL and LAN to PANEL cables. I recommend using the following: * https://www.amazon.com/gp/product/B01J7KVPCK/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1 * https://www.amazon.com/gp/product/B07C4Y471P/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 I suggest using temperature-resistant materials because the inside of the case can get hot enough to deform standard PLA. I didn't test it, but I think PETG or ABS would be a good choice. Assemble the case using M5 bolts and mount the electronics using M3 bolts. If the connectors don't fit perfectly, you can add some washers to raise the boards. The top cover has 4 holes that face directly onto the left holes of the hub board and right holes of the MiSTer IO board, so you'll need 4 spacers here. I made a breadboard with 3 pushbuttons and 3 LEDs and connected it to the relevant connectors on the io board. I used 3mm LEDs and 6x6x10mm pushbuttons (you can also use 6x6x8mm). The keyboard is fixed to the case using strong double-sided tape. There's a slot for the micro USB cable connector on the keyboard side because it's angled. If you have a micro USB to USB cable with small micro USB connectors, they should fit without problems. There are two versions of the BACK USB case: V1 is for V1 to V1.1 usb hubs and V2 is for V1.2 and V2.1 usb boards. I only have a V1.1 usb board, so I wasn't able to test the V2, but it should work. The front right part has a placeholder for a 2.5" SSD or HDD. I suggest using one with a directly connected USB port instead of an adapter. Finally, you can glue the "MiSTer" writing on top case (there's a placeholder) or simply leave it empty.