MiSTer BlisSTer Sidecar Case

thingiverse

This custom sidecar enclosure is designed for use alongside my primary MiSTer case. The Micro USB 3 port is safely secured at the back with a snug-fitting opening to prevent strain and protect against damage. A minor issue exists with the power button, which is slightly loose; I plan to explore a more secure option in the future. Print Instructions: - Print the bottom, rear, front, power, and two reset components. - Layer height: 0.2mm Assembly Steps: 1. Insert the power button. 2. Place the reset button on the same side as the power button. 3. Carefully position the BlisSTer PCB, keeping the buttons in place. 4. While holding at an angle, insert the second reset button. 5. Slide the PCB towards the rear of the case to secure the front panel. 6. Insert the rear panel. 7. Adjust the PCB's placement and screw it into position using M3 screws. Feedback is greatly appreciated!