miniture shelf

thingiverse

this is a small shelf i designed. if you are going to mount it in sheet rock you will have to use the spacers. put wall anchors in the sheet rock. mount the spacers on the wall with the screws tight. there is a counter sink area for the screw head to sink into and be flush with the mount. then angle the shelf slide the mounts into the slots and you're done. it was drawn to be 200mm tall or wide, depending on how you are looking at it. simplify3d shows a printing time of 39 hours with 10percent infill, 1mm nozzle at .32mm layer height. i would suggest to print it on its side. i use an ender3 so i have no choice, but i have done some shelf brackets in the same fasion as this shelf and printed them on the side and they came out great.