Minimalist Wallet

thingiverse

Slick minimalist wallet that fits your pocket seamlessly. You will need 24mm fabric elastic band. Money Strap = 80 to 95mm x 24mm fabric elastic band. Side and Bottom Straps = 40mm by 24mm fabric elastic band. Straps are sewed to the clips using the holes closes to the center of the wallet body when fitted. If you prefer you can also sew the second strip of holes which will have a stronger hold and less elasticity due to reduced travel. The strap will clip into the body. No need for glue. Warning: If you test fit the clips after printing you may have a hard time getting them out. In case you need to remove them use a pair of pliers to gently squeeze the clip hooks together and then use a large flat nose screw driver and twist the head in between the body and the clip and it should come out. Or simply use pliers to break the clip hooks by squeezing hard and print a new one. Approx 9 mins per clip. Material: PLA Layer height: 0.2mm Print Speed 40mms (Depends on the capability of your printer) Supports: Touching build plate (If printing face up) else print face down with no supports. For best results print using a layer height of 0.2. Face up with supports and enable Ironing to make the last layer smooth which will give a nice matt look that blends in with the beveled edges. The layered bevel will then not be as apparent. Or for a more easier print. Print face down then you wont need any supports. However if printing on a smooth surface such as glass the smoothness of the glass do not blend well with the beveled layered edges. Experimental Ideas: Print Face up using TPE/TPU flexible filament and pause the print at layer height 0.8 Then swap the filament with PLA to print the rest. This could give the insides a rubbery surface protecting your cards against abrasion. Caveat: I cannot get PLA to bond to TPE it simply just pulls off.