Minimalist Huawei Watch Charging Stand - Mk. 2

thingiverse

After about five months of using my original minimalist Huawei Watch changing stand, I wrote down all the things I disliked about it and set out to fix them. A few improvements include: Single piece printing - No more will you have to glue multiple pieces together or hope for a friction fit to hold. Charging puck removal hole - Pulling the puck out by the cord worked, but seems like a bad solution long term. Now there's a finger hole so you can pop it out from behind. Tighter USB cable channel - The USB cable now holds itself in nicely, and the channel prints more easily without any bridging to speak of. No more silly alignment fins - While I still stand by the theory, the practice was they were useless (at best) or caused a problem (at worst). So they're gone. No more weighted base - Again, I stand by the theory, but in practice the weight made little difference and just added complexity to the print. Reduced puck recession - The puck now sticks out from the charger by a millimeter or two. This should make it easier to get the watch aligned every time. Pretty rounded corners - The addition of rounded edges allows for a sleek futuristic art-deco look... or, really, means you won't catch your fingers on any plastic edges in the early morning. All in all, I'd say Mk. 2 is a significant improvement over Mk. 1 both in terms of appearance and functionality and would recommend this over the older version to anyone wanting a Huawei Watch stand. Printer Brand: Deezmaker Printer: Bukito Rafts: No Supports: No Resolution: .1-.3 Infill: As you like it Notes: This should print quite easily. Arrange it so the flat right side is against the bed and the base/puck holder are sticking up in the air.