Minimalist Card Holder (Vase Mode)

prusaprinters

I found a bunch of card holders, but all took ages to print and were overly complex and tough. This was inspired by Playing Card Holder by crazycollie, which on my printer with my profile took 10 hours and 70 grams of filament to print. I descided to use vase mode and decreased the print time to 3 and a half hours, and the material to just 19gram. Print settings are important! Don't just print with your usual settings. Please see print settings below. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: .65 Filament: AnyCubic PLA Red Notes: Print on it's side and use vase mode or Spiralize outer contour. Set the bottom layers to 0, and use a**0.65mm line width**. You can do this line width with a regular 0.4 nozzle no worries, just decrease the speed a bit. On my printer I use 60mm/s. You can stretch the model width as desired. The default 200mm width seems right for most cardgames. It's probably best to print two stands rather than one super wide one. Category: Games